DPO4104 LABVIEW DRIVER DOWNLOAD

Sorry if this is in the wrong place. In this case, you will use a regular straight-through twisted-pair Ethernet cable to connect each device to the hub. I’ll try to post the solution when when I get it working. However, this saves it with a random default name from the scope. I also had fun because I had to recieve the data in chunks since an entire png file could not be transfered in one chunk due to buffer limitations. Everything else is the same.

Uploader: Shakasar
Date Added: 12 October 2009
File Size: 52.45 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87363
Price: Free* [*Free Regsitration Required]

Acquire Screen Capture VI. Message 3 of I managed to figure it out. I am currently automating a test that must set a scope to certain parameters, with a single trigger. Message 3 of 3. I can’t believe I didn’t realize that! Message 2 of 3.

Message 5 of 5. For Ethernet, pairs 1 and 2, and 3 and 6 are used. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Here are the commands I used.

  GATEWAY CX2728 DRIVER

Configuring a Tektronix Oscilloscope to Communicate with a Crossover Ethernet Cable

I can not open VI stillbut you know that it saves locally scope path, not PC? Can I connect three or more devices together?

Thanks laabview your help guys. Message 4 of Back to Top 3. Most Active Software Boards: In this dialog, we want to turn off Obtain an IP address automaticallyand switch it to Use the following IP address. Message 6 of Ben64 The best way to say thanks is to give kudos! Be sure that the IP address and Subnet mask match the numbers shown above.

The other solution I labviwe seen is to save the screen shot to a flash drive, then copy the file through the port to the PC. Learn more about our privacy policy. Press OK Accept to apply the changes.

How to save to USB on DPO – Discussion Forums – National Instruments

The main problem I am still having is: Back to Top 2. Most of the commands still function properly and I’ve fixed a lot of pdo4104 does not using the programming manual for the series DPO and MSO Now we need to verify that we configured everything correctly and that our cable is working okay.

  BCR2000 USB MIDI DRIVER DOWNLOAD

Most Active Hardware Boards: First, you need to get to the network configuration control panel.

You might want to concider using a PNG format as it will make the file size smaller. Message 2 of 5.

Thank you so much for pointing that out to me. Eventually I would like to program a Tektronix DPO B oscilloscope to trigger dlo4104 a rising edge for a number of cycles.

Thank you for your response Evan.